总字数:9569

摘 要

温度较高时,仅使用风扇不能消除人体热不舒适,空调风扇联合运行的调节方式比仅使用空调、风扇能更好的改善人体热感觉。同时,通过相关性检验分析得出对人体热感觉影响程度相关的环境因素排序为:风速、温度、平均辐射温度。本文从节能角度出发,采用单片机技术和传感器技术设计一款基于温度检测的智能家居恒温控制系统,该系统通过STC89C52单片机输入的信号进行处理控制输出,通过温度检测模块DS18B20检测当前室内的温度,通过人体热释电检测当前是否有人,检测到有人,根据当前的温度对风扇和空调进行控制,并可以控制风扇是否进行摇头。因此,空调风扇联合运行可通过风扇制造空气流动,提高空调控制温度,降低能耗,这种运行模式可在类似、家居、仓储房这样的中推广使用。

关键字:智能家居空调;风扇;节能;热舒适;联合运行

Abstract

When the temperature is high, only using the fan cannot eliminate the thermal discomfort of the human body. The adjustment mode of combined operation of the air conditioner and fan can better improve the thermal sensation of the human body than only using the air conditioner and fan. At the same time, through the correlation test analysis, it is concluded that the environmental factors related to the influence degree of human thermal sensation are sorted as wind speed, temperature and average radiation temperature. From the perspective of energy saving, this paper uses single-chip microcomputer technology and sensor technology to design a smart home constant temperature control system based on temperature detection. The system processes and controls the output through the input signal of STC89C52 single-chip microcomputer, detects the current indoor temperature through the temperature detection module DS18B20, and detects whether there are people at present through the pyroelectricity of human body. If someone is detected, you can control the fan and air conditioner based on the current temperature, and control whether the fan shakes its head. Therefore, the combined operation of the air conditioner fan can create air flow through the fan, improve the temperature control of the air conditioner and reduce energy consumption. This operation mode can be popularized in the similar, home, storage room and so on.

Key words: intelligent home air conditioning; A fan; Energy saving; Thermal comfort; Combined operation

目  录

1 绪论 5

1.1 研究背景目的及其研究意义 5

1.2 国内外研究现状 5

1.3.1 国内研究现状 5

1.3.2 国外研究现状 6

1.3 研究功能 7

2 系统方案设计 8

2.1 系统方案设计 8

2.2 主要模块方案选择 8

2.2.1 主控模块方案选择 8

2.2.3 风扇驱动模块方案选择 9

3 硬件设计 10

3.1 主控模块电路 10

3.2 温度检测模块电路 10

3.3 人体热释电感应模块 11

3.4 继电器模块电路设计 11

3.5 显示模块电路设计 12

3.6 直流电机驱动模块电路 12

3.7 步进电机模块电路设计 13

3.8按键模块电路设计 13

4 系统程序设计 15

4.1 编程软件介绍 15

4.2 系统主机主流程设计 15

4.3 独立按键 16

4.4 步进电机子流程 17

4.5 温度检测模块子流程 18

5 仿真测试 20

5.1 空调仿真测控 20

5.2 风扇测控仿真测试 21

6结论 23

参考文献 24

致  谢 25

附录 26

附录一:仿真图 26

附录二:主程序 27

……………..本设计说明书是配套实物或仿真来写的,完整的设计参考书请购买后下载,购买过程遇到任何问题请联系客服进行咨询。本资料是一次性商品,不支持退货,感谢您对单片机俱乐部的支持……………..

发表回复

后才能评论

本站所有资源版权均属于原作者所有,这里所提供资源均只能用于参考学习用,请勿直接商用。若由于商用引起版权纠纷,一切责任均由使用者承担。更多说明请参考 VIP介绍。

最常见的情况是下载不完整: 可对比下载完压缩包的与网盘上的容量,若小于网盘提示的容量则是这个原因。这是浏览器下载的bug,建议用百度网盘软件或迅雷下载。 若排除这种情况,可在对应资源底部留言,或联络我们。

对于会员专享、整站源码、程序插件、网站模板、网页模版等类型的素材,文章内用于介绍的图片通常并不包含在对应可供下载素材包内。这些相关商业图片需另外购买,且本站不负责(也没有办法)找到出处。 同样地一些字体文件也是这种情况,但部分素材会在素材包内有一份字体下载链接清单。

如果您已经成功付款但是网站没有弹出成功提示,请联系站长提供付款信息为您处理

源码素材属于虚拟商品,具有可复制性,可传播性,一旦授予,不接受任何形式的退款、换货要求。请您在购买获取之前确认好 是您所需要的资源